crwdns2915892:0crwdne2915892:0
In this guide, we will show you how to remove and replace the Memory Modules.
crwdns2942213:0crwdne2942213:0
-
-
Disconnect the battery cable from the system board.
-
-
-
Remove the screws that secure the battery to the palm-rest assembly.
-
-
-
Lift the battery off the palm-rest assembly.
-
-
-
Press and hold the power button for five seconds to ground the system board.
-
-
-
Align the screw holes on the battery with the screw holes on the palm-rest assembly.
-
-
-
-
Replace the screws that secure the battery to the palm-rest assembly.
-
-
-
Connect the battery cable to the system board.
-
-
-
Lift the Mylar to access the memory module.
-
-
-
Use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot until the memory module pops up.
-
-
-
Remove the memory module from the memory-module slot.
-
-
-
Lift the Mylar to access the memory-module slot.
-
-
-
Align the notch on the memory module with the tab on the memory-module slot.
-
-
-
Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
-
NOTE: If you do not hear the click, remove the memory module and reinstall it.
-
crwdns2915084:0crwdne2915084:0
RampUP America, Inc. crwdns2935289:0RampUP America, Inc.crwdne2935289:0
Community
crwdns2931471:042crwdne2931471:0
crwdns2935297:01,988crwdne2935297:0
