crwdns2915892:0crwdne2915892:0
When replacing electrical components on any device careful consideration must be taken to reduce risk of shock. Be sure the cord is not plugged into a power source before proceeding with this replacement guide. If the cord is cut, this should not be an issue. Reasons you might need follow this guide include: damaged power cord, or the grinder wont turn on.
crwdns2942213:0crwdne2942213:0
-
-
Turn to the bottom of the device and remove the 5/8" (17mm) T15 Torx screw.
-
-
-
Remove bottom casing by separating the end handle away from the main casing.
-
-
-
Remove the 1/2” (13mm) Phillips #2 screw holding the power cable to the device. This will free up the metal clamp holding the cable in place.
-
-
-
-
Flip the grinder over and disconnect the plastic switch mechanism from the cable housing.
-
-
-
Pull back the yellow tab holding the housing in place using a nylon spudger. Carefully pull the housing out of the casing.
-
-
-
Locate the terminals with the two white cables attached and disconnect both.
-
-
-
Remove the entirety of the cable housing from the device casing.
-
-
-
Loosen the Phillips #2 screws enough to disconnect the two wires from the power cable housing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Oregon Institute of Technology, Team S2-G9, Lancaster Spring 2019 crwdns2935289:0Oregon Institute of Technology, Team S2-G9, Lancaster Spring 2019crwdne2935289:0
OIT-LANCASTER-S19S2G9
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Where can I find a replacement power cord?
