crwdns2915892:0crwdne2915892:0
The carbon brushes are one part that both wears out quickly and can cause a wide variety of problems if faulty. Follow these simple steps to replace them.
crwdns2942213:0crwdne2942213:0
-
-
Turn to the bottom of the device and remove the 5/8" (17mm) T15 Torx screw shown using a T15 Torx Screwdriver.
-
-
-
Remove the outer casing to expose the brushes by pulling the end handle away from the field case.
-
-
-
-
Locate both carbon brushes on either side of the device.
-
-
-
Using the iFixit opening tool, remove the female terminal connecting the carbon brush wire to the male terminal.
-
-
-
Keeping a tight hold the entire time, move the spring covering the carbon brush so that it is behind the male terminal.
-
-
-
Taking hold of the wire you removed in step 4, gently slide the carbon brush out of its casing and remove it from the device.
-
Flip over the device to reveal the second carbon brush, and repeat steps 4 through 6 on the other side.
-
Congratulations! To put your device back together, simply reverse the above steps.
Congratulations! To put your device back together, simply reverse the above steps.
crwdns2915084:0crwdne2915084:0
Oregon Institute of Technology, Team S2-G9, Lancaster Spring 2019 crwdns2935289:0Oregon Institute of Technology, Team S2-G9, Lancaster Spring 2019crwdne2935289:0
OIT-LANCASTER-S19S2G9
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
