crwdns2915892:0crwdne2915892:0
This guide will show you the necessary steps to replace the saw blade. The blade is not included in these pictures.
-
-
Take out the Allen Key that is located on the front of the saw below the smooth control handle on the top of the saw.
-
-
-
Use the Allen Key to replace to loosen the bolt where the center of the saw is/would be.
-
-
-
-
Remove the circular nut that is used to hold the saw blade in place. It slide right off.
-
-
-
Lift up the plastic cover on the bottom to expose the bottom slot on the saw.
-
-
-
Place blade on the peg in the middle of the saw. The peg has two flat sides as does the saw hole to prevent slipping when spinning.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 8-2, Banghart Winter 2017 crwdns2935289:0Cal Poly, Team 8-2, Banghart Winter 2017crwdne2935289:0
CPSU-BANGHART-W17S8G2
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
