crwdns2915892:0crwdne2915892:0
This guide will show you how to remove the boot of the saw in order to replace it.
crwdns2942213:0crwdne2942213:0
-
-
Use a T-20 hexhead screw to unscrew 4 hexagonal screws surrounding the base of the black air filter. The screws are on the yellow portion.
-
-
-
Use a T-15 hexhead screw to unscrew 5 hexagonal screws. These screws are located on the opposite side of the saw from previous step.
-
-
-
Unscrew the black plastic knob underneath the trigger.
-
-
-
-
Grab hold of the black air filter portion and pull off.
-
-
-
This is what the inside of the saw looks like.
-
-
-
Use a T-15 hex head screw to unscrew the four screws located around the outside of the motor.
-
-
-
Using an H 4.0 hex head screw, unscrew the bolt located right above the boot that is next to the motor of the saw.
-
-
-
Pull the blade away from the body of the saw causing the blade and boot to detach.
-
-
-
Pull the boot downwards away from the blade to detach it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.