crwdns2942213:0crwdne2942213:0
-
-
Using an H-5.0 bit driver remove the four T-10 Torx screws.
-
-
-
Use 2 H-5.0 bit drivers to take out the main bolt and head.
-
-
-
-
Carefully remove the two halves of the handle.
-
-
-
Locate the switch on the top of the drill right before the bending joint.
-
-
-
Firmly grasp the switch with two fingers and lift it straight up. The spring should remain attached to the switch during this process.
-
crwdns2935219:0crwdne2935219:0
To reassemble your device, follow these instructions in reverse order.
crwdns2915888:0crwdne2915888:0
To reassemble your device, follow these instructions in reverse order.
crwdns2917034:0crwdne2917034:0
This guide was descriptive and easy to follow. Good job!