crwdns2915892:0crwdne2915892:0
If you realize your battery charger for your drill is not charging, there may be a blown fuse which can be replaced by following this guide.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four 13 mm, Torx Security #15 screws found on the bottom of the charger.
-
-
-
-
Remove the 19 mm, Torx Security #10 screw found in the charger port.
-
Then pull the top of the charger off separating it from the bottom.
-
-
-
Once you have located the fuse, if you have the replacement fuse just pull the old one out and put the new one in.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Can i get some help in locating the fuse in mt dcb 112 dewalt battery charger i cant found it