crwdns2915892:0crwdne2915892:0
The DeWalt D26451 power switch turns the sander on and off. It may not be working because the circuit is out of alignment, there is a tripped breaker, or a stripped wire.
Replacing the power switch may fix your on/off issues. In this guide, we will be teaching you how to replace the switch. You can order a replacement switch here.
crwdns2942213:0crwdne2942213:0
-
-
Remove screws (3) from cap by using the T20 torx attachment and unscrewing in a leftward motion.
-
-
-
Gently pry the cap off using your fingers or spudger tool.
-
-
-
Once cap is off, expose and locate the power cord mounting bracket and remove the 2 screws holding the wire down by using the T15 torx attachment. Once the cord is loose, pull the connectors out
-
-
-
-
Loosen the white and black wire terminals
-
-
-
Insert new power cord terminals and tighten down
-
Do not over-tighten
-
-
-
Remove screws (3) from the cap using a T20 torx attachment by unscrewing in a leftward motion
-
-
-
Once the cap is removed, the switch and connectors should be exposed
-
-
-
Remove both connectors from the switch
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0