crwdns2915892:0crwdne2915892:0
I show how it is opened.
crwdns2942213:0crwdne2942213:0
-
-
First unplug the cable. ...Pull off the lever, it is snapped in.
-
Pull out the drawer.
-
Now clean it with a vacuum.
-
On the underside are 4 screws Torx 10 resistant visible - in each corner one.
-
-
-
here you have two pictures of the housing and the chrome plastic frame.
-
-
-
Here you have details of the lever and how it is snapped in the mechanic.
-
This shows you how to unlock it when you dismantle the housing. Good luck. ;)
-
-
-
-
Detail of the Sensor: It is the little black pearl at the black hoses which is strapped to the white hose.
-
-
-
The connector from the main platine to the switch platine.
-
-
-
Details of the plug and the bottom part after disassembly.
-
Where to find the plug for the yellow ground wire i show you in the next step. :)
-
-
-
here you can see where the yellow cable belongs to.
-
-
-
Reassembly: Putt all cables at the right places, don't forget the yellow cable at the housing !!!
-
Look at the picture how to fit in the metal notch in the right place !
-
-
-
Here the notch is in the right place.
-
Do NOT forget to make an insulation test. Check the wiring with a multimeter.
-
Made in China.
-
Hope it was fun and may the pictures help you. Greets. :)
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2947412:02crwdne2947412:0
The lever broke on my toaster. And it's difficult to glue it.
My daughter toasted a piece of bread but the bread burned and caught fire. I've opened the toaster, and see no fire-damage. Although, it is impossible to toast because the lever won't stay down.
