crwdns2894164:0crwdne2894164:0

crwdns2892376:0crwdne2892376:0

I phoned D-Link tech support several times, and they eventually concluded my device was broken, but I got it fixed.

My D-Link dhp w306av would do nothing but blink it's blue (WPS/ENY) LED. None of the support people could fix it with any kind of reset. This is what I managed to do.

crwdns2860944:0crwdne2860944:0

crwdns2860947:0crwdne2860947:0

crwdns2890040:0crwdne2890040:0

  1. (With router unpluged, and no ethernet cable attched) Turn the router on (push in the power button on the side) remember it's not plugged into the wall yet.
    • (With router unpluged, and no ethernet cable attched) Turn the router on (push in the power button on the side) remember it's not plugged into the wall yet.

  2. Take a pin or micro screwdriver and push in and hold the reset button.
    • Take a pin or micro screwdriver and push in and hold the reset button.

    • Still holding the reset button plug the router into a power outlet.

    • Keep holding down the reset button for at least 15 seconds.

    • If you have the same luck I did your green lights on the side will start to cycle and light up.

    • Now you can go back to your quick install guide that came with the router and set it up again.

crwdns2892372:0crwdne2892372:0

hope it works for you

crwdns2878426:04crwdne2878426:0

alan

crwdns2886885:023/08/2013crwdne2886885:0

1 crwdns2894548:0crwdne2894548:0

crwdns2882065:0crwdne2882065:0

crwdns2892924:00crwdne2892924:0

crwdns2892926:0crwdne2892926:0

crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 0

crwdns2894768:07crwdne2894768:0 0

crwdns2894768:030crwdne2894768:0 0

crwdns2894770:0crwdne2894770:0 5,895