crwdns2915892:0crwdne2915892:0
This guide will show you how to disassemble a Cuisinart PowerPrep Plus DLC-2014CHB. Potential hazards may include the heavy weight of the food processor; do the disassembly on a flat, wide surface to avoid any risk of dropping and to ensure that the device is properly supported. This repair may be needed because of a misaligned/faulty weight sensor, burnt out LEDs, faulty motor, etc.
crwdns2942213:0crwdne2942213:0
-
-
Remove four 17 mm screws from the bottom panel of the processor with a Phillips #2 screwdriver.
-
Remove the bottom panel from the main food processor chassis.
-
-
-
Remove three 15 mm screws to free the control panel from the chassis bracket using a Phillips #2 screwdriver.
-
-
-
-
Remove two 10 mm screws to free the button circuit board from the bracket using a Phillips #2 screwdriver.
-
Remove three 10 mm screws attached to the circuit board to detach from the bracket panel using a Phillips #2 screwdriver.
-
-
-
Remove two 10 mm screws connecting the weight sensor to the front panel using a Phillips #2 screwdriver.
-
-
-
This device operates by first detecting the cup through a weight sensor. Then, by pressing pulse, on, or dough, the motor rotates a rod which the blade attachment fits onto.
-
There is an on/off button which turns the various components on, and the lights indicate which modes are active. The motor does not heat up enough for a need for temp regulation.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Tufts University School of Engineering, Team 1-3, Carlson Fall 2024 crwdns2935289:0Tufts University School of Engineering, Team 1-3, Carlson Fall 2024crwdne2935289:0
TUFTS-CARLSON-F24S1G3
crwdns2931471:02crwdne2931471:0
crwdns2935303:01crwdne2935303:0
