crwdns2915892:0crwdne2915892:0
Use this guide to replace the "Chop" and "Grind" buttons located on the Cuisinart Mini-Prep DLC-2A.
crwdns2942213:0crwdne2942213:0
-
-
Remove the back panel using a Phillips #1 Screwdriver on the four screws that hold it in place.
-
-
-
Locate the Button Panel inside the blender.
-
Using your Phillips #1 Screwdriver, remove the two screws which hold the panel in place.
-
-
-
-
Locate the black box held in place on the panel.
-
Using your Spudger, wedge the black box out of its place to uncover the button
-
-
-
Once the black box is out of place, use your finger to push out the button.
-
Now replace the old button with your newly acquired button.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
University of North Texas, Team S3-G1, Thompson Fall 2017 crwdns2935289:0University of North Texas, Team S3-G1, Thompson Fall 2017crwdne2935289:0
UNT-THOMPSON-F17S3G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Hi,
Where’d you get the new buttons?
