crwdns2915892:0crwdne2915892:0
If your cooking surface isn't turning on or is being pushed up you may need to replace a spring, a process which will be explained in this guide.
crwdns2942213:0crwdne2942213:0
-
-
Remove cooking plates by pushing in the tabs on each side of the plate at the same time.
-
-
-
Remove the six 5.5mm Phillips #2 screws that secure the bottom heating coil to the device.
-
-
-
Remove the four 30 mm Phillips #2 screws that secure the bottom heating apparatus.
-
-
-
-
Remove the single 5.5 mm Phillips #2 screw next to center black button.
-
After removing the center screw the metal plate should be free to remove.
-
-
-
Lift the bottom heating apparatus up and remove large black center piece by pushing down on black button while sliding out.
-
Realign all surface and put device back together making sure all parts are lined up and heating surfaces are making contact.
-
The aligned parts will allow the cooking surfaces to work properly.
-
-
-
Depress one of the gray tabs on the side of the housing.
-
-
-
Pull out the black button and the spring will also come out within it.
-
-
-
Pull out the spring, and insert the replacement spring making sure it is correctly aligned.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 1-12, Maness Spring 2016 crwdns2935289:0Cal Poly, Team 1-12, Maness Spring 2016crwdne2935289:0
CPSU-MANESS-S16S1G12
crwdns2931471:04crwdne2931471:0
crwdns2935297:06crwdne2935297:0
