crwdns2942213:0crwdne2942213:0
-
-
Turn the device upside down.
-
Remove all four rubber feet by prying them out using the metal spudger.
-
Once the rubber feet have been removed, use the Phillips #2 screwdriver to remove all four 13mm screws.
-
-
-
Remove the base from the body of the blender.
-
-
-
-
Remove the two 11mm screws securing the power cord using the Phillips #2 screwdriver.
-
Gently move the wire aside so that it is not in the way.
-
-
-
Remove the four 13mm screws that hold the black plastic cover using the Phillips #2 screwdriver.
-
Gently remove the black cover.
-
Underneath, you will see a clear plastic cover that should be removed as well.
-
-
-
Cut the zip tie that holds the black, blue, red, and yellow wires together.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0