Creality CR-20 X Gantry Alignment

crwdns2931653:01crwdne2931653:0 X Gantry Alignment




• The CR-20 Pro has solid bed mounts. If any X axis gantry alignment is needed, you can use the "nozzle to bed" distance to check.
• With M2.5 hex, loosen the 2 button head screws on the back side/ right of the X/Z Bracket.
• If the right side is too low and needs to go up, squeeze the bracket and rail together while tightening the button head screws.
• If the right side is high and needs to be lowered, you will squeeze the bottom wheel against the X rail while tightening.
• When properly adjusted, the nozzle will be the same distance from the bed from left to right.
• In some cases, it is necessary to do this process on the left side (near extruder motor) but requires partial disassembly of the machine.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2862417:0crwdne2862417:0

crwdns2935291:0crwdnd2935291:01crwdnd2935291:0crwdne2935291:0

Tiny Machines 3D

crwdns2935283:011/16/19crwdne2935283:0

2 970 crwdns2915208:0crwdne2915208:0

crwdns2935297:014crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 17

• 
• 
• 

crwdns2935301:014crwdne2935301:0

crwdns2915084:0crwdne2915084:0

Tiny Machines 3D crwdns2935289:0Tiny Machines 3Dcrwdne2935289:0

Community

crwdns2931471:05crwdne2931471:0

crwdns2935297:040crwdne2935297:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

crwdns2852917:0crwdne2852917:0