crwdns2915892:0crwdne2915892:0
Often times it is only necessary to replace the carbon brushes, not the motor. Carbon brushes experience a lot of friction, and replacement is generally expected over time. Ensure your saw is unplugged before beginning the repair
crwdns2942213:0crwdne2942213:0
-
-
Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor.
-
-
-
-
Using a Phillips #00 screwdriver or a small diameter nail, carefully pull out the washer.
-
-
-
After the washers are removed, gently grab the old brushes and remove them from the motor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.