crwdns2915892:0crwdne2915892:0
If the scroll wheel sensor on your Corsair Katar mouse is broken, this guide will show you how to replace it.
crwdns2942213:0crwdne2942213:0
-
-
Flip the mouse over so the bottom is facing up.
-
-
-
Remove the three skates on the bottom of the mouse using the plastic opening tools.
-
-
-
Use the JIS 0 screwdriver to remove the four 5 mm screws on the bottom of the mouse.
-
-
-
-
Detach the bottom of the mouse from the upper shell.
-
Use the plastic opening tool to detach the white DPI sensor cable from its port.
-
-
-
Use the JIS 0 screwdriver to remove the two 5mm screws on the motherboard.
-
-
-
Use the plastic opening tool to pry the white cable jack away from the motherboard.
-
Lift the motherboard away from the bottom of the mouse.
-
-
-
Push the scroll wheel to the right side of the motherboard as shown, then pull it away from the board to remove.
-
-
-
Flip the motherboard over and remove the clear plastic cover from the bottom of the board.
-
-
-
Desolder the 5 connecting pins to remove the scroll wheel sensor from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
UW Tacoma, Team S1-G3, Cardinal Summer 2018 crwdns2935289:0UW Tacoma, Team S1-G3, Cardinal Summer 2018crwdne2935289:0
UWT-CARDINAL-SU18S1G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:012crwdne2935297:0
crwdns2944067:02crwdne2944067:0
bonsoir moi ma molette tourne dans le vide rien ne accroche merci
Do I need new pads when I take out the old ones or will the same one stick?
