crwdns2942213:0crwdne2942213:0
-
-
Slide battery latch to left
-
Simultaneously lift battery
-
-
-
Lift the keyboard in the middle with a spudger
-
Remove 4 clips by bending keyboard in middle, do not force the clips at the sides
-
Do not remove the keyboard fully, it is attached via a ribbon cable
-
-
-
-
Lift keyboard slightly
-
Push each side of ribbon cable connector
-
Fully remove keyboard
-
-
-
Remove 2x Phillips M2.5x8mm screws from under the display
-
Remove 4x Phillips M2x2.8mm screws from the battery compartment
-
-
-
Turn over the laptop
-
Use a spudger to lift the ribbon cable hinged clip
-
Pull the ribbon cable out of the connector
-
-
-
Lifting the bezel by the screen
-
Slide the bezel back towards the screen to release it from the clips
-
-
-
Disconnect the display cable
-
Disconnect the microphone connector
-
Pull out the microphone LED from it's clip
-
Unroute the cables from their holders
-
-
-
Pull the wifi antennas through from the back of the laptop
-
Unroute the antenna cables from their guides
-
-
-
Remove 4x Phillips #1 M2.5x8mm screws from display hinges
-
Carefully lift display out making sure no cables are snagged
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0