crwdns2915892:0crwdne2915892:0
Power not reaching your motherboard? Does the lantern not illuminate even though its been charged? Check out this guide on how to remove and replace the battery!
crwdns2942213:0crwdne2942213:0
-
-
Carefully turn the lantern upside down.
-
Remove the three 1.2 mm Phillips #0 screws from the base of the lantern.
-
-
-
Carefully pull the bottom of the lantern to remove the base from the device.
-
-
-
-
Gently pull the battery out of the slot and away from the base.
-
-
-
Carefully detach the negative wire from the battery terminal first.
-
Next, detach the positive wire from the battery terminal.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Washington State, Team S2-G1, Hope Fall 2018 crwdns2935289:0Washington State, Team S2-G1, Hope Fall 2018crwdne2935289:0
WSU-HOPE-F18S2G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:08crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Sean, I’m facing a dead battery in my Coleman twin tube fluorescent lantern also. Your directions are spot on except my battery seems to be glued in with super glue! I’ve tried a heat gun and all my strength but my battery won’t come loose. I find it hard to pry under the battery because of the shape of the plastic partitions around the battery. How did you get the battery unstuck?
