crwdns2915892:0crwdne2915892:0
The purpose of this guide is to give step-by-step instruction on how to replace the motherboard on a ColecoVision.
crwdns2942213:0crwdne2942213:0
-
-
Start by laying the console face down.
-
Remove the eight 15mm Phillips #1 screws from the bottom of the device.
-
-
-
Flip the console back over.
-
Lift the front panel off. I would reccomended using a metal spudger along the rim of the top to safely remove it and set it aside.
-
-
-
-
Remove the two 15mm Phillips #1 screws holding the casing in place.
-
Carefully lift the casing from the motherboard.
-
-
-
Remove the center Phillips #1 screw near the cartridge slot.
-
Remove the second Phillips #1 screw near the RAM chips.
-
Carefully lift and remove the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
UW Tacoma, Team S1-G2, Rose Fall 2018 crwdns2935289:0UW Tacoma, Team S1-G2, Rose Fall 2018crwdne2935289:0
UWT-ROSE-F18S1G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:012crwdne2935297:0
