crwdns2915892:0crwdne2915892:0
Follow this guide to remove the belt guide in order to replace it, or to access the belt and pulley.
crwdns2942213:0crwdne2942213:0
-
-
Disconnect the spark plug to prevent the engine from accidentally starting up during service:
-
Grab the plastic housing at the end of the spark plug wire.
-
Pull firmly to disconnect the wire from the spark plug.
-
-
-
To prevent the over seeder from rolling during service, place wheel chocks behind a rear wheel.
-
-
-
-
Push down on the main handle to tilt the over seeder back on its rear wheels.
-
Place some weights on the handle, or tie the handle down, to prevent the machine from falling forward.
-
-
-
Place a wheel chock in front of a rear tire to keep the machine in place.
-
-
-
Remove the four lock nuts securing the belt guard:
-
Two 1/2" lock nuts
-
Two 7/16" lock nuts
-
-
-
Remove the belt guard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
