crwdns2915892:0crwdne2915892:0
This guide shows how to remove and replace the blower housing for a Clarke Floor Sander 07014A.
crwdns2942213:0crwdne2942213:0
-
-
Twist and pull the dust bag collar to disconnect it from the elbow pipe.
-
Remove the dust bag.
-
-
-
Peel the rubber sleeve down from the elbow pipe to reveal the pipe socket.
-
-
-
-
Grasp the elbow pipe with your hands and pull up while twisting to disconnect it from the blower housing.
-
Remove the elbow pipe.
-
-
-
Twist and pull to disconnect both suction hoses from the blower housing.
-
-
-
Remove the four 22mm long Phillips screws around the side of the blower housing.
-
-
-
Lift the blower housing upwards and slide it off of the blower assembly.
-
Remove the blower housing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Were do you get the sticker?
