crwdns2915892:0crwdne2915892:0
This guide will take you step by step through the process of replacing your speakers.
crwdns2942213:0crwdne2942213:0
-
-
Remove the top (button side) rubber cover using your hands.
-
-
-
Flip over the device and remove the bottom rubber cover using your hands.
-
-
-
Using your hands, pull off the plastic side cover (on the side with the audio jack) using the indented tab. The indented tab has been highlighted in the picture.
-
-
-
-
Detach the plastic speaker cover on both the front and back sides. Then slide the cover off of the device.
-
-
-
Remove the five 1 cm screws on the back side (opposite of the speakers) of the device using a Phillips #1 screwdriver.
-
-
-
Gently pull apart the two sections of the device.
-
-
-
Separate the wires so that each white cap distinctly has a single red and single black wire coming out of it.
-
-
-
Disconnect the two sets of wires by pulling on the wires until the white cap detaches from the circuit board.
-
-
-
Detach the solder points on each gold speaker in order to release and remove them.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.