crwdns2915892:0crwdne2915892:0
This guide is a step-by-step process on how to replace the zoom lens on a Casio Exilim EX-Z850 camera. This will help you replace it if it is broken or damaged, and there are no special skills required for this project.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four screws on the side with the screwdriver.
-
-
-
Remove the four screws from the bottom of the camera.
-
-
-
With the screwdriver, remove the four screws on the side of the speaker.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Once all screws have been removed, gently pry open the bottom casing.
-
With tweezers, carefully remove ribbon from LCD screen.
-
Set the bottom casing aside.
-
-
-
Remove ribbon from the rear casing.
-
Set aside the rear casing.
-
-
-
Use tweezers or prongs to pry the LCD screen off from the opening.
-
-
-
Lift up the LCD screen, and slowly move it to the other side.
-
-
-
-
With tweezers, pry off the LCD casing which is taped on to the frame.
-
-
-
With tweezers, flip open the connector holding the ribbon.
-
Pull out the LCD screen with the ribbon from the camera.
-
-
-
Pull apart the front casing, and set it to the side.
-
-
-
Remove two screws on the side where the battery is located.
-
Remove the lanyard loop after the screws come off.
-
Slowly pull the side casing so it becomes dislocated from the top of the camera frame.
-
-
-
On the front of the camera near the flash flip the connector holding the ribbon.
-
Carefully remove the ribbon from the connector.
-
-
-
Carefully remove the L shaped frame from the camera.
-
At the bottom of the camera the L shaped frame is being held in by two plastic bumps and a metal tab. Pop the frame off the bumps and tabs.
-
There is a yellow and orange wire soldered onto the camera. Be careful not to pull them off.
-
-
-
On the logic board next to the lens is a connector with a ribbon.
-
Flip the connector and remove the ribbon with the tweezers.
-
-
-
Remove the frame on the back side of the camera where the LCD screen was.
-
With the screwdriver, remove the two screws connecting the frame with the camera
-
Slowly pry off the frame from the camera
-
After removing the frame a plastic piece with two yellow button connections should fall off.
-
-
-
On the back of the camera where the LCD screen was, remove the 3 screws located behind the lens.
-
-
-
Remove the large orange ribbon previously held in by screws from the camera and set it asside.
-
-
-
On the backside of the camera where the indicator lamp is located, remove the two screws with a screwdriver
-
-
-
On the side of the indicator lamp remove a screw.
-
On the front side of the indicator lamp remove the a screw.
-
This should remove the indicator lamp from the lens.
-
-
-
The lens is now detached from the camera except for the ribbon soldered onto the logic board.
-
To put the Casio Exilim EX-Z850 camera back together, reserve the instructions to follow them in a backward manner.
To put the Casio Exilim EX-Z850 camera back together, reserve the instructions to follow them in a backward manner.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 4-38, Regan Winter 2011 crwdns2935289:0Cal Poly, Team 4-38, Regan Winter 2011crwdne2935289:0
CPSU-REGAN-W11S4G38
crwdns2931471:04crwdne2931471:0
crwdns2935297:013crwdne2935297:0
