crwdns2915892:0crwdne2915892:0
This guide is the pre-requisite to all guides involving the replacement or repair of the internal components of the camera. Before you begin, please note that some screws will be covered with foam protectors.
crwdns2942213:0crwdne2942213:0
-
-
Remove the strap by undoing the Velcro and pulling it through the thread points.
-
Remove the external battery pack by pressing down on the slide release and sliding it out.
-
-
-
Remove the three 5mm Phillips #000 screws on the bottom of the device.
-
-
-
On the side of the device, remove the following Phillips #000 screws:
-
One 3mm screw
-
One 5mm screw
-
-
-
-
Remove the panel opposite the display by pulling up perpendicular to the side.
-
-
-
Remove the 4mm Phillips #000 screw that was exposed after taking off the side panel.
-
-
-
Remove the three 4mm Phillips #000 screws shown.
-
-
-
Using tweezers, disconnect this ribbon cable by pulling straight out.
-
-
-
Repeat step seven (7) for the remaining three wires shown.
-
-
-
Grasp the top of the camera and pull straight up to remove the top panel.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Central Washington University, Team S1-G3, Pengilly Fall 2018 crwdns2935289:0Central Washington University, Team S1-G3, Pengilly Fall 2018crwdne2935289:0
CWU-PENGILLY-F18S1G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:010crwdne2935297:0
