crwdns2915892:0crwdne2915892:0
This guide will help replace the internal battery and SD card reader, and opens up the central capturing unit to be disassembled
crwdns2942213:0crwdne2942213:0
-
-
Remove the strap by undoing the Velcro and pulling it through the thread points.
-
Remove the external battery pack by pressing down on the slide release and sliding it out.
-
-
-
Remove the three 5mm Phillips #000 screws on the bottom of the device.
-
-
-
On the side of the device, remove the following Phillips #000 screws:
-
One 3mm screw
-
One 5mm screw
-
-
-
Remove the panel opposite the display by pulling up perpendicular to the side.
-
-
-
Remove the 4mm Phillips #000 screw that was exposed after taking off the side panel.
-
-
-
Remove the three 4mm Phillips #000 screws shown.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using tweezers, disconnect this ribbon cable by pulling straight out.
-
-
-
-
Repeat step seven (7) for the remaining three wires shown.
-
-
-
Grasp the top of the camera and pull straight up to remove the top panel.
-
-
-
Remove the 5mm Phillips #000 screw on top of the inner case.
-
-
-
Remove the two 5mm Phillips #000 screws near the display panel.
-
-
-
Disconnect the small bundled cable connector on the side of the lens cover by pulling it straight out.
-
-
-
Remove the lens cover by pulling straight away from the body.
-
-
-
Remove the three 6mm Phillips #000 screws shown.
-
-
-
Remove the lens by pulling straight away from the main body.
-
-
-
Remove the two 3mm Phillips #000 screws.
-
Remove the 4mm Phillips #000 screw.
-
-
-
Remove the 4mm Phillips #000 screw at the bottom of the camera.
-
-
-
Place the spudger under the tab shown.
-
While prying the tab up with the spudger, pull the case away.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.