crwdns2915892:0crwdne2915892:0
This guide will show you how to access the components of the manual zoom to repair or replace broken elements.
crwdns2942213:0crwdne2942213:0
-
-
On the right side of the camcorder remove the grip belt.
-
-
-
On the bottom of the battery hold the battery release switch.
-
-
-
Remove the battery slowly away from the camcorder.
-
-
-
Remove the two 8mm Philips #000 screws on the side where the grip belt was located on.
-
-
-
Remove the two 4mm Philips #000 head screws from the bottom of the camcorder.
-
A hidden 4mm Philips #000 screw is shown under the black plug shown.
-
-
-
-
Near the LCD screen, remove the three 7mm Philips #000 screws in the picture shown.
-
-
-
Carefully place the camcorder where the inside of the device is facing upwards and remove the 3mm Philips #000 screw shown.
-
-
-
Using the spudger, pull the tab shown to start removing the ribbon cable.
-
-
-
Using the Spudger, carefully remove the two ribbon cables that are connected to the top of the device.
-
-
-
Remove the three 6mm Philips #000 screws holding the black record piece.
-
-
-
Holding the full top piece remove the six 5mm Philips #000 screws holding the metal frame to the top piece.
-
-
-
Carefully remove the the whole metal frame out of the device piece.
-
-
-
Replace the defective speaker with a functioning one.
-
-
-
Examine the grey zoom input tab located on copper plate.
-
Examine the black plastic zoom slider, on the top cover of the camera
-
Repair or replace damaged components and clear all debris from mechanisms.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0