crwdns2915892:0crwdne2915892:0
If the lens cover on your camera will not open or close it could be caused by debris blocking the mechanism or a broken mechanism component. This guide will show you how to remove the lens cover from your camera so you can clean or repair it.
crwdns2942213:0crwdne2942213:0
-
-
On the right side of the camcorder remove the grip belt.
-
-
-
On the bottom of the battery hold the battery release switch.
-
-
-
Remove the battery slowly away from the camcorder.
-
-
-
Remove the two 8mm Philips #000 screws on the side where the grip belt was located on.
-
-
-
Remove the two 4mm Philips #000 head screws from the bottom of the camcorder.
-
A hidden 4mm Philips #000 screw is shown under the black plug shown.
-
-
-
-
Near the LCD screen, remove the three 7mm Philips #000 screws in the picture shown.
-
-
-
Carefully place the camcorder where the inside of the device is facing upwards and remove the 3mm Philips #000 screw shown.
-
-
-
Using the spudger, pull the tab shown to start removing the ribbon cable.
-
-
-
Using the Spudger, carefully remove the two ribbon cables that are connected to the top of the device.
-
-
-
Remove the two 5mm Phillips #000 screws near the LCD screen.
-
-
-
Remove the single 5mm Phillips #000 screw located on the top of the camera near the lens cover.
-
-
-
Unplug the cord connecting the camera to the lens cover. Grip the white plug near the port and pull it out.
-
-
-
The lens cover is detached from the camera and can now be removed.
-
Repair or replace damaged components in the lens cover.
-
Ensure lens cover mechanism is free of debris.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Western Carolina University, Team 1-5, Virtue Spring 2016 crwdns2935289:0Western Carolina University, Team 1-5, Virtue Spring 2016crwdne2935289:0
WCU-VIRTUE-S16S1G5
crwdns2931471:05crwdne2931471:0
crwdns2935297:016crwdne2935297:0
