crwdns2915892:0crwdne2915892:0
User will need spudger, plastic pry tools, and PH00 screwdriver.
crwdns2942213:0crwdne2942213:0
-
-
Rotate the camera to expose the underside of the camera.
-
-
-
Slide the rounded rectangle tab to the left to release the battery cover.
-
-
-
Push the small orange tab forward to release the battery (Battery is ready for removal).
-
-
-
Using the Phillips 00 screwdriver, remove the two 4mm top screws above the LCD screen.
-
-
-
Using the Phillips 00 screwdriver, remove the two 4mm side screws to the left of the LCD screen.
-
-
-
-
Using the Phillips 00 screwdriver, remove the two 4mm side screws to the left of the LCD screen.
-
-
-
Using the Phillips 00 screwdriver, remove the three 4mm screws from the underside of the camera.
-
-
-
Using the plastic pry tool, remove the back cover from camera.
-
-
-
Using spudger, lift the tab on the connector and remove the orange ribbon from motherboard (LCD screen is separated from camera).
-
-
-
Using the Phillips 00 screwdriver remove the seven 6mm screws from the housing plate of the LCD screen.
-
-
-
Using the Phillips 00 screwdriver, remove the 4mm mounting screw from underneath the flash.
-
-
-
Using the spudger, lift the flash unit away from the metal housing (Flash is lifted to allow more room for metal housing).
-
-
-
Using the spudger, remove the metal housing (Metal housing is removed from camera).
-
-
-
Using the spudger, lift the tab on the ZIF connector and remove both orange ribbons connected to the green motherboard (Motherboard is lifted from camera).
-
-
-
Remove the lens from the lens shaft (Lens is removed from camera).
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0