crwdns2915892:0crwdne2915892:0
Quick guide on removing and replacing the plastic back cover. Replacement is required if the functions buttons fail to work, or the casing has been damaged.
crwdns2942213:0crwdne2942213:0
-
-
Position the camera so that the right side is visible as shown.
-
Unscrew the two 6 mm screws shown using a screwdriver.
-
-
-
Remove the plastic flap by pressing down on the center of the hinge and pulling on the flap with the spudger.
-
Then, unscrew the lone 6mm screw that was under the plastic flap.
-
-
-
Turn the camera so that the bottom is visible, as shown.
-
Unscrew the three 4mm screws shown red using a screwdriver.
-
Unscrew the single 6mm screw.
-
Do not touch the screw shown yellow, removal is unnecessary. (Note: the top right yellow screw should be removed)
-
-
-
-
Turn the camera so the back side is visible, as shown.
-
Unscrew the two 6mm screws.
-
-
-
Gently remove the back cover using the spudger.
-
-
-
Detach the wire by lifting the small black bar that holds it to the main body of the camera.
-
-
-
Attach the new cover onto the camera.
-
-
-
Reattach the wire to your new rear casing.
-
-
-
Close the back cover, and re-insert appropriate screws.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 5-12, Maness Spring 2015 crwdns2935289:0Cal Poly, Team 5-12, Maness Spring 2015crwdne2935289:0
CPSU-MANESS-S15S5G12
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947410:01crwdne2947410:0
yellow marked screw must come out to remove cover next to battery door
