crwdns2915892:0crwdne2915892:0
The buttons on the user interface panel can become broken or stuck. This guide will show how to replace the user interface panel on the Canon PowerShot SD1400 IS.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four 2.0 mm Phillips screws of the camera using the J00 bit from the 54-bit Driver Kit. There are two screws on both sides.
-
-
-
Remove the 4.0 mm Phillips screw located on the bottom of the camera.
-
-
-
-
Remove the front face panel of the camera by hand using firm pressure.
-
If one point of the face is stuck to the body, check if there is a screw preventing the front face from coming off.
-
-
-
Remove the rear panel of the camera by hand using firm pressure.
-
-
-
Remove the user interface panel by hand. The panel may fall out on its own, this is normal.
-
Replace the user interface panel by setting it in position.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0