crwdns2915892:0crwdne2915892:0
The image capture button can break or become stuck. This guide details how to replace the image capture button and the surrounding plastic housing on the Canon PowerShot SD1400 IS camera.
crwdns2942213:0crwdne2942213:0
-
-
Use a Phillips #00 driver to remove the four 2.0 mm Phillips screws on the camera housing.
-
-
-
Use a Phillips #1 driver to remove the one 4.0 mm Phillips screw located on the bottom of the camera.
-
-
-
Remove the face housing from the body of the camera.
-
-
-
Turn the camera over and remove the rear housing.
-
-
-
-
Remove the button panel if it did not fall out on its own.
-
-
-
Use a Phillips #0 driver to remove the one 3.0 mm Phillips copper screw from the top of the camera.
-
-
-
Use a Phillips #0 driver to remove the one 3.0 mm Phillips silver screw from the rear face of the camera.
-
-
-
Use a plastic spudger to lift the golden film off of the microchip on the front face of the camera, exposing a screw.
-
-
-
Use a Phillips #0 driver to remove the one 3.0 mm Phillips screw.
-
-
-
Use a metal spudger to carefully pry the small black tab away from the connector that secures one end of the golden film.
-
-
-
Carefully insert a metal spudger under the two clusters of wires that are plugged into the small chip on the face of the camera.
-
Pull the wires parallel to the face of the camera to disconnect them from the small chip.
-
-
-
The image capture button housing can now be removed from the body of the camera and replaced.
-
Follow these instructions in reverse order to reassemble the device.
Follow these instructions in reverse order to reassemble the device.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Baylor, Team S1-G3, Johnson Spring 2018 crwdns2935289:0Baylor, Team S1-G3, Johnson Spring 2018crwdne2935289:0
BU-JOHNSON-S18S1G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Where can do you buy replacement parts?
