crwdns2942213:0crwdne2942213:0
-
-
Remove the two 2.9 mm screws from the side panel closest to the camera lens.
-
-
-
Remove the two 2.9 mm screws from the camera bottom panel.
-
-
-
Remove the two 2.9 mm screws from the side panel farthest from the lens.
-
-
-
Pull the back panel away from the camera body, starting at the end with the function buttons.
-
-
-
-
Remove the small cover panel and the attached wrist strap mount.
-
-
-
Remove the front cover by gently pulling it away from the camera body.
-
-
-
Place the front cover, back cover, and wrist strap mount in a safe place until you are ready for reassembly.
-
-
-
Remove the two 2.4 mm screws located at the top of the LCD panel.
-
-
-
Pull up the metal frame surrounding the LCD screen starting at the side of the camera.
-
-
-
Push the metal frame away from the metal tab using the spudger to detach the frame.
-
Rotate the metal frame upwards.
-
-
-
Carefully lift the metal frame from the camera.
-
Remove the black LCD screen, leaving the thin lens pieces in place.
-
-
-
Carefully pull on the orange connector ribbon to disconnect the LCD screen.
-
The LCD screen can be pulled out of the frame before disconnecting its connector ribbon.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 8-18, Maness Winter 2012 crwdns2935289:0Cal Poly, Team 8-18, Maness Winter 2012crwdne2935289:0
CPSU-MANESS-W12S8G18
crwdns2931471:04crwdne2931471:0
crwdns2935297:012crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Very helpful. These units still sell for a lot more than the cost of the replacement LCD
