crwdns2915892:0crwdne2915892:0
Use this guide to replace the Canon PowerShot A75's flash unit.
crwdns2942213:0crwdne2942213:0
-
-
Turn the camera over and locate the "BATT OPEN" sliding switch.
-
-
-
Remove the three 2.5mm screws on the bottom of the camera.
-
-
-
Remove the 3.8mm screw underneath the flap that covers the A/V port.
-
-
-
Remove the 2.4mm screw located underneath the cover of the memory card slot.
-
-
-
-
Open the memory card slot by sliding it laterally until you hear a click.
-
Remove the 5.9mm screw in the upper corner of the memory card slot.
-
-
-
Remove the two 4.1mm screws at the bottom of the battery flap.
-
-
-
Lift the shutter button and speaker part from the top of the camera.
-
-
-
Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out.
-
-
-
Remove the rightmost 4.2mm screw underneath the battery cover, not the center screw.
-
-
-
Separate the back casing and front casing of the camera using your hands.
-
-
-
On the front of the camera, press the button on the lower left of the lens.
-
Twist the outer lens casing counter-clockwise and slide it out.
-
-
-
Rotate the camera such that the flash unit and capacitor are facing you.
-
Remove the 3.5mm screw located between the flash unit and the capacitor.
-
-
-
Snap flash unit out of place with your fingers.
-
Unsolder the five wires connected to the flash unit in order to remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.