crwdns2915892:0crwdne2915892:0
Use this guide to replace the shooting mode dial on your Canon PowerShot A630 camera.
crwdns2942213:0crwdne2942213:0
- 
   
   - 
                     
            Open the battery door by sliding the tab on the battery door while pushing the battery door away from the camera. 
- 
                     
            Remove batteries. 
 
- 
                     
            
- 
   
   - 
                     
            Remove the three indicated .2mm screws using a Phillips #00 screwdriver. 
- 
                     
            Gently pull off side-panel to remove it. 
 
- 
                     
            
- 
   
   - 
                     
            Remove the two indicated .2mm screws using a Phillips #00 screwdriver. 
 
- 
                     
            
- 
   
   - 
                     
            Remove the indicated .2mm screw using a Phillips #00 screwdriver. 
- 
                     
            Remove the three .2mm screws located on the internal side of the top panel within the battery chamber using a Phillips #00 screwdriver. 
 
- 
                     
            
- 
                     
                                                
- 
   
   - 
                     
            Open 'DIGITAL A/V OUT' door on camera. 
- 
                     
            Remove the two indicated .2mm screws using a Phillips #00 screwdriver. 
 
- 
                     
            
- 
   
   - 
                     
            Grip the sides of the top panel and gently pull to separate the top panel from the camera body. 
 
- 
                     
            
- 
   
   - 
                     
            Gently pull the front and back panels apart, and use a Phillips #00 screwdriver to remove the screw connecting the panels. 
- 
                     
            Gripping the top and bottom, gently pull the front panel away from the camera body to remove it. 
 
- 
                     
            
- 
   
   - 
                     
            Pry open the connector on the yellow ribbon cable using a plastic opening tool. 
 
- 
                     
            
- 
   
   - 
                     
            Remove the 2 mm screws from the metal plate. 
 
- 
                     
            
- 
   
   - 
                     
            Pull away the metal plate, exposing the underbelly of the mode dial. 
 
- 
                     
            
- 
   
   - 
                     
            Remove the 2mm screw using the #00 Phillips screwdriver. 
- 
                     
            The mode dial should fall out. 
 
- 
                     
            
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
