crwdns2915892:0crwdne2915892:0
Use this guide to replace or repair your speaker.
crwdns2942213:0crwdne2942213:0
-
-
Orient the camera so that the viewfinder is on your left and the lens is on your right.
-
Remove the 4mm #00 Phillips screw.
-
-
-
Reorient the camera with the back button pad and viewfinder towards you.
-
Remove the three 4mm #00 Phillips screws shown on the rear face of camcorder.
-
-
-
Remove the plastic cover from the rear of the camcorder by gently pulling it towards you while holding the camera as shown.
-
-
-
Remove the 4mm #00 Phillips screw located to the right of the LCD release switch.
-
-
-
Open the LCD by using the release switch.
-
Reorient the camera with the playback button pad and edge of LCD screen facing you.
-
Remove the 4mm #00 Phillips screw shown.
-
-
-
Reorient the camera with the top facing you. The side with the LCD screen should be on the right and the other side panel should be on the right.
-
Open the pop up flash on the top of the camcorder.
-
Remove the 4mm #00 Phillips screw shown.
-
-
-
Reorient the camera with the bottom facing you, LCD screen on the right, side panel on the left.
-
Open the tape deck by sliding the switch and moving the deck cover to the left as shown.
-
-
-
-
Reorient camera with lens facing you.
-
Remove the #00 Philips 4mm screw shown on the hinge of the tape deck cover.
-
-
-
To remove the camcorder lens hood, twist the hood to counterclockwise and it will come loose, then pull towards you.
-
-
-
Close the tape deck by gently pushing it toward the body of the camera.
-
Slide and remove the plastic cover on the bottom right, exposing the interface shown.
-
-
-
Gently pull the front plastic cover towards you to remove.
-
-
-
Remove 2 Philips #00 4mm screw shown.
-
-
-
Reorient the camera so you are looking at the side of the camera with the viewfinder on the left and lens on the right.
-
Holding the camera as shown,remove the 4mm #00 Phillips screw.
-
-
-
Remove the 4 Philips #00 4mm screws shown.
-
-
-
Reorient the camera with the lens facing you.
-
Gently pull the side panel of the camera to the right to remove.
-
-
-
Remove the screw above the speaker's housing.
-
-
-
Remove the small battery with the "Caution" on it.
-
-
-
Remove the screw from inside the battery housing.
-
-
-
Remove the 3 screws holding the metal piece over the speaker.
-
-
-
Replace the broken speaker with a new one.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 1-12, Amido Winter 2011 crwdns2935289:0Cal Poly, Team 1-12, Amido Winter 2011crwdne2935289:0
CPSU-AMIDO-W11S1G12
crwdns2931471:04crwdne2931471:0
crwdns2935297:011crwdne2935297:0
