crwdns2915892:0crwdne2915892:0
If your camcorder LCD screen is scratched, cracked or defective in any way, it will have to be replaced. This guide requires some tools and time.
crwdns2942213:0crwdne2942213:0
-
-
Locate battery compartment cover. Turn the device over and locate the battery compartment cover.
-
Place a finger or thumb on the textured section of the battery compartment cover and push forward until you hear a click. Then lift the battery compartment cover.
-
-
-
Locate the grey latch and move it aside. The battery is spring loaded and will pop up.
-
Remove the battery.
-
-
-
-
Using the Phillips #000, remove the two screws on the LCD panel.
-
Using the Phillips #000, remove two more screws near the LCD panel swivel point.
-
-
-
Use the plastic opening tool to remove the plastic cover from the LCD panel.
-
-
-
Locate and remove two screws on the logic board.
-
Use the plastic opening tool to open the ZIF (zero insertion force) connector. The LCD ribbon should pop up.
-
-
-
Locate the LCD screen underneath the logic board and slide it out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0