crwdns2915892:0crwdne2915892:0
Use this guide to remove the two metal neck strap loops.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
-
-
-
On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
-
Pry up the panel; starting from the front/bottom corner, as indicated.
-
There's a concealed lip, under the opposite edge.
-
-
-
Remove three medium length screws from the bottom of the camera
-
-
-
Remove the two medium length screws on the front panel of the camera above the lens mount.
-
Once you done, you may use the Spudger to panel from non-grip side.
-
-
-
Remove the three long black screws from the bottom using a #00 Phillips screwdriver.
-
Use tweezers to lift the panel.
-
-
-
Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.
-
-
-
-
Remove the two 4.5mm (.18in) long black screws from the camera grip using a #00 Phillips screwdriver.
-
-
-
Use your fingertip to pry off the external shutter port cover.
-
-
-
Remove the two 5mm (.20in) long silver screws securing the grip to the camera using a #00 Phillips screwdriver.
-
-
-
Use the spudger tool to carefully pry the grip from the rest of the camera.
-
-
-
Once the grip is loose, use your fingers to remove it from the camera.
-
-
-
Grasp the eyepiece with your fingers and slide upwards to remove it.
-
-
-
Remove the following ribbons with the tweezers by gently pulling on them.
-
Remove the three black screws, near the eye piece, using the Phillips Screwdriver.
-
-
-
Remove the cable heads attached on the front side of the camera next to the lens mount.
-
-
-
You can use your fingers to pull the top panel of the camera.
-
-
-
Remove the two 5.0mm (.20in) silver screws from the first loop hole using a #00 Phillips screwdriver (Picture Two).
-
Remove the 6.8mm (.27in) wide head silver screw from the second loop hole using a #00 Phillips screwdriver (Picture Three).
-
-
-
Use your fingers to remove the loop holes.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 3-41, Regan Winter 2011 crwdns2935289:0Cal Poly, Team 3-41, Regan Winter 2011crwdne2935289:0
CPSU-REGAN-W11S3G41
crwdns2931471:02crwdne2931471:0
crwdns2935297:021crwdne2935297:0
