crwdns2915892:0crwdne2915892:0
This guide will instruct you how to install the flash on your camera.
crwdns2942213:0crwdne2942213:0
-
-
Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
-
-
-
Using your finger, peel back the textured grip so the components are separated.
-
-
-
Using the flat end of a spudger, loosen the connection between the front panel and the device.
-
Remove the front panel using your hands.
-
-
-
-
Pop the flash up with your thumb
-
-
-
Unscrew the two screws on the front of the flash near the bulb cover.
-
-
-
Close the flash.
-
Lift the flash cover off.
-
-
-
Pull off yellow capacitor from flash wiring.
-
-
-
Remove white cocking with a razor blade, and then unsolder connection.
-
-
-
Remove the flash cover to access the flash bulb.
-
After wires are unsoldered, slide flash bulb out from housing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0