Canon EOS 60D Rear LCD Screen Replacement
crwdns2944107:0crwdnd2944107:0Alejandro Cabreracrwdnd2944107:0crwdnd2944107:0crwdnd2944107:02crwdnd2944107:0crwdne2944107:0
crwdns2944111:0February 1, 2020crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0If you drop the camera and break the LCD screen, or if the screen just stops functioning, this guide will help you replace it.
Be sure to use a magnetic mat or small container for your screws, as they are very small and easy to misplace.
crwdns2942213:0crwdne2942213:0
crwdns2943215:0crwdne2943215:0
crwdns2944105:0crwdne2944105:0
-
-
Take the LCD out of its place to expose the Phillips #PH00 screws.
-
Remove the two 2.5 mm Phillips #PH00 black screws on both sides of the LCD screen.
-
Next remove the two 3 mm Phillips #PH00 black screws near both sides of the base where the screen swivels.
-
-
-
Using a plastic opening tool, carefully pry off the back cover of the LCD.
-
-
-
Remove the 3 mm Phillips #PH00 silver screw on the side of the screen.
-
Turn the screen to remove the second 3 mm Phillips #PH00 silver screw.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using the tweezers, carefully disconnect the rear connector by pulling it away from the screen.
-
-
-
Remove the two 2.5 mm Phillips #PH00 silver screws using the PH00 screwdriver.
-
Using the plastic Spudger opening tool, carefully lift up on the medal tabs next to where the screws were located.
-
-
-
Finally, remove the LCD screen by grabbing the clear plastic tab and lifting it carefully.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 16-6, Wollert Fall 2015 crwdns2935289:0USF Tampa, Team 16-6, Wollert Fall 2015crwdne2935289:0
USFT-WOLLERT-F15S16G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:014crwdne2935297:0
