crwdns2915892:0crwdne2915892:0
If your date and time battery needs to be replaced, follow this guide to replace it. The required date and time battery is a CR2016 lithium.
crwdns2942213:0crwdne2942213:0
-
-
Locate the battery compartment cover on the bottom of the camera below the shutter button.
-
-
-
Find the marked arrow on the battery compartment cover labeled "BATT. OPEN". Slide the lever following the arrow's direction and lift at the same time to release the latch.
-
-
-
-
Release the lever and allow the battery compartment cover to completely open.
-
Remove the battery.
-
-
-
Remove the date and time battery holder by sliding it out of the slot.
-
-
-
Remove the date and time battery from the battery holder.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:08crwdne2935229:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 12-3, Blackwell Fall 2015 crwdns2935289:0USF Tampa, Team 12-3, Blackwell Fall 2015crwdne2935289:0
USFT-BLACKWELL-F15S12G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:016crwdne2935297:0
crwdns2944067:05crwdne2944067:0
Thank you. This is fantastic information that is *not* in the manual. I bought an unnecessary main battery, but this resuscitated my camera on a trip.
Thanks! David D.
All the other advice I found says to remove two screws, when it's really as simple as you show here. Thanks!
This was so helpful, thank you! Also if you are in a jam and do not have a CR2016, you can use a CR2032 directly without using the normal battery tray.
Great help! Accurate, easy to follow directions
Excellent. Just what I needed, to bring life back to the dead.
