crwdns2915892:0crwdne2915892:0
If the back lock-release lever is loose or broken, this will allow you to attempt to replace it.
crwdns2942213:0crwdne2942213:0
-
-
Remove the batteries from the camera by sliding them out into your palm.
-
-
-
Release the side latch to open the back panel.
-
-
-
-
Remove the two black 4.5mm screws above and below the latch.
-
-
-
Using your finger, carefully pry open the side panel from the top of camera.
-
Pull panel downwards to remove.
-
-
-
Remove the two silver 6mm Phillips #1 screws.
-
-
-
Flip camera over to the bottom.
-
Remove the one 5mm Phillips #1 silver screw.
-
-
-
Remove the front panel by pulling away from the side with the lever.
-
-
-
Pull off the lever by pushing up from the bottom and pulling away from the bottom.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0