crwdns2915892:0crwdne2915892:0
This guide is a quick solution to fix worn out roller skate wheels! Rather than spend lots of money on a new pair, just replace your old wheels to get your roller skates spinning smoothly again!
crwdns2942213:0crwdne2942213:0
-
-
Use a 13mm wrench to loosen the nuts in the center of the wheel(s) that need to be replaced.
-
Remove the nuts from the axel.
-
-
-
Slide the wheel off the axel and check your axel for dirt, grease, or hair.
-
Clean the axel thoroughly.
-
-
-
-
Check over the new wheels to make sure they don’t have any issues.
-
-
-
Place the wheel on the axel.
-
Thread the nut onto the axel on top of your wheel with your fingers.
-
-
-
Tighten the nut using the 13mm wrench.
-
-
-
Once you have it on there tightly, loosen it a little to allows your wheels to roll smoothly and not rub. Test your wheels by spinning them with your finger.
-
Test your wheels by spinning them with your finger.
-
This is a simple replacement with very easy-to-follow instructions. If you followed all the steps exactly, you will be skating again in no time!
This is a simple replacement with very easy-to-follow instructions. If you followed all the steps exactly, you will be skating again in no time!
crwdns2915084:0crwdne2915084:0
Idaho State University, Team S1-G5, Watkins Summer 2021 crwdns2935289:0Idaho State University, Team S1-G5, Watkins Summer 2021crwdne2935289:0
ISU-WATKINS-SU21S1G5
crwdns2934841:01crwdne2934841:0
crwdns2935297:02crwdne2935297:0
