crwdns2915892:0crwdne2915892:0
Use this guide if your Boss RC-1 Loop Station is not turning on (indicated by the red light at the top of the device). This guide will go through taking apart the device to access, remove, and replace the battery.
Disconnect all power sources. Remove any cables connected to the ports (also known as jacks) of the device. Never work on a device that is plugged into a power outlet.
crwdns2942213:0crwdne2942213:0
-
-
Push down on the pedal in order to relieve pressure on the thumbscrew.
-
-
-
Remove the thumb screw at the bottom of the device.
-
-
-
-
Using the Phillips #0 screwdriver, remove the two screws that secure the pedal to the device.
-
-
-
Disconnect the snap chord from the battery.
-
-
-
Reassemble the device in the opposite order.
-
To check if the batter replacement was successful, plug in a guitar cable into the “Output A” jack. If the red light turns on below the “check” (top of the device), then the looper pedal is working.
To check if the batter replacement was successful, plug in a guitar cable into the “Output A” jack. If the red light turns on below the “check” (top of the device), then the looper pedal is working.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Embry-Riddle Aeronautical University, Team S7-G5, Rauch Spring 2021 crwdns2935289:0Embry-Riddle Aeronautical University, Team S7-G5, Rauch Spring 2021crwdne2935289:0
ERAU-RAUCH-S21S7G5
crwdns2934841:01crwdne2934841:0
crwdns2935303:01crwdne2935303:0
