crwdns2942213:0crwdne2942213:0
-
-
lay the speaker flat onto its back.
-
-
-
use your heat gun to soften the adhesive that holds the grill in place.
-
using your flat head screwdriver, carefully pry up on the grill on all sides.
-
leave the grill to one side
-
-
-
using your philips head screwdriver, unscrew the 6 screws holding the speaker assembly in place.
-
using your heat gun, apply heat to the edges to again soften the adhesive seal.
-
using your flat head screwdriver, carefully pry up into the speaker's body.
-
when separating the speaker, carefully pull on the connectors on it
-
when putting the speaker assembly back together, again, replace the adhesive on the speaker and body.
-
-
-
-
using your phillips head screwdriver, unscrew all the screws that are attached to the motherboard.
-
using your flat head screwdriver, carefully pry the motherboard out.
-
-
-
carefully pry into the connector on the motherboard connected to the battery.
-
-
-
take the battery out of its slot.
-
take a pair of scissors and carefully cut open the foam casing just enough to take out the battery.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
