crwdns2915892:0crwdne2915892:0
If your phone does not vibrate, you should replace the vibrator. You will need to follow multiple prerequisite guides in order to complete this repair.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two plastic plates with a plastic opening tool.
-
-
-
Using a Phillips #000 screwdriver, remove the 3mm screws. Be sure to do this for the top and bottom of the phone.
-
-
-
Remove SIM card tray with paperclip or SIM card tray removal tool.
-
Push down on the phone beside the camera and up on the backplate with your thumbs to remove the back plate. Remove adhesive if necessary.
-
-
-
Place the plastic opening tool in the highlighted indent, and push up on the battery to remove it.
-
-
-
-
Remove the exterior cover with a Torx 2 screwdriver, to remove two 3.0mm screws.
-
Remove the 4.0mm screw with a Phillips #000 screwdriver.
-
Using the blue plastic opening tool, remove the exterior cover.
-
-
-
Use a Phillips #000 screwdriver to remove each of the four 1.5mm screws.
-
Use a Phillips #000 screwdriver to remove each of the three 3.0mm screws.
-
Use the plastic opening tool to remove the speaker.
-
-
-
Disconnect the black wire with a pair of tweezers.
-
-
-
Use a pair of tweezers to remove the orange data cable as shown.
-
-
-
Use the plastic opening tool to lift the microphone out of place.
-
Use a pair of tweezers to lift the microphone out of the phone.
-
-
-
To remove the vibrator, use the plastic opening tool to pry it out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Washington State, Team S9-G2, Hope Fall 2018 crwdns2935289:0Washington State, Team S9-G2, Hope Fall 2018crwdne2935289:0
WSU-HOPE-F18S9G2
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
