crwdns2915892:0crwdne2915892:0
Be prepared with the tools that are listed and be cautious while going through the steps as some of the components maybe fragile.
crwdns2942213:0crwdne2942213:0
-
-
Locate the groove at the bottom left corner of the phone.
-
Insert the plastic opening tool in the groove and pry it open.
-
Lift the back cover of the phone using your hands.
-
-
-
Pry the battery out from the back of the phone using the plastic opening tool.
-
-
-
Remove the 12 screws located at the back panel of the phone using a J000 screwdriver.
-
The red circles are screw holes that hold the 3.5mm length Phillips screw.
-
The orange circles are screw holes that hold the 2.5mm length Phillips screw.
-
-
-
-
Remove the back panel of the phone with your hand.
-
-
-
Remove the antenna cable connectors using a spudger.
-
-
-
Unscrew the 2.5mm screws from the circuit board holding the speaker at the bottom of the phone.
-
-
-
Flip the ZIF flap up with tweezers.
-
Remove the ribbon cable with tweezers.
-
-
-
Remove the speaker panel with the plastic opening tool.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.