crwdns2915892:0crwdne2915892:0
This page gives instructions for disassembling the Black and Decker WP900 6-Inch Orbital Waxer and Polisher to the point where the power cable can be fully removed and replaced.
crwdns2942213:0crwdne2942213:0
-
-
Using the plastic tool, detach the handle tab as shown.
-
-
-
Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.
-
-
-
-
Remove the back panel of the external casing, leaving all internal components resting in the front panel.
-
Remove the black handle from the main external casing.
-
-
-
Loosen the power cord and control panel. Using the Phillips #1 screwdriver, remove two 22mm screws.
-
Using the Flathead 3/32" screwdriver, remove two 22mm screws.
-
-
-
Gently pull the power cord out from the control module.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.