crwdns2915892:0crwdne2915892:0
This guide is to replace the Lithium Ion battery located in the main body of the Black and Decker Pivot Max. No special tools are necessary, only a phillips screw driver is needed for this replacement.
crwdns2942213:0crwdne2942213:0
-
-
Press in and hold the release button.
-
Rotate the dust filter chamber counter-clockwise.
-
Remove the dust filter chamber.
-
-
-
Remove the two 10 mm screws from the motor casing with a Phillips #1 screwdriver.
-
-
-
-
Pull the battery cover up and then slide it away from the motor to remove.
-
-
-
Remove the battery unit by pulling it out of the main body.
-
-
-
Disconnect the quick connect wire harness that connects the motor and battery located in the battery storage compartment.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:025crwdne2935229:0
crwdns2915084:0crwdne2915084:0
IUPUI, Team S5-G6, Baechle Fall 2017 crwdns2935289:0IUPUI, Team S5-G6, Baechle Fall 2017crwdne2935289:0
IUPUI-BAECHLE-F17S5G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2947412:028crwdne2947412:0
any idea where to find the replacement battery? Does it come as a unit or do you need to disassemble the battery pack and replace the cells?
Where do I get the cells to replace the old ones?
How do you disconnect the quick connect
My battery pack is soldered to a circuit board. There is no quick connect. (Model BDH2000PL, Type 2).
Same here. Worst design ever.
