crwdns2915892:0crwdne2915892:0
This guide will show you how to replace the motor on the Black and Decker PS1800.
crwdns2942213:0crwdne2942213:0
-
-
Lay the drill on its side, assuring that the screw holes are facing upwards.
-
Remove seven 12 mm screws using a Phillips #00 screwdriver.
-
-
-
Separate the outer drill case to expose the components and switch.
-
-
-
-
Locate the motor at the top left hand corner.
-
Carefully disconnect the red and black wires attached to the motor.
-
-
-
Unscrew the motor from the drill's transmission.
-
-
-
Remove the motor from the transmission assembly, as pictured.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0